What is there to consider when using the VR headset?

Abby Legge Updated by Abby Legge

For comfortable driving in the Yaak simulator, it is important to adjust the VR headset optimally. To do this, the headset have a dial at the back of the head that can be used to adjust them comfortably and to the right height. Various joints allow you to adjust the fit of the headset. The lenses of the headset should sit level with your eyes.

A dial on the bottom left of the headset is used to adjust the lenses to the distance between your eyes. With a little trial and error, the image quality can be significantly improved.

The VR headset can be worn over optical glasses without any problems.

There is a rocker switch on the bottom right-hand side of the headset, which is used to adjust the volume.

The on/off switch is located on the left-hand side of the front, outer edge of the headset. By tapping this switch, you can put the headset into standby mode and wake it up from this mode. By holding the switch for a long time, you can switch the headset off and on completely. You should not normally do this.

The connecting cable of the headset should be routed to the rear with sufficient clearance. There should be no strong tension on the cable.

Clean the glasses with disinfectant wipes before and after use.

Important: Please never place the headset in direct sunlight. This can damage the built-in screens!

Was this article helpful?

Which drives are available in the simulator?

What else is there to consider when using the simulator?

Contact